Fast By Gast Logo
   
Checker
 
SEARCH our PRODUCTS
" size="13">
Bar

   Categories

   
New Products
 
Race Parts
 
Specials
 
Tech Tips
 
Race Team
 
 
Hot Deals
     You Are Here: Home / Race Parts / Carburetor / Initial Metering Rod Setting

Initial Metering Rod Setting


The best way to achieve initial setting is to use a fuel ratio tool, this tool will actually measure the taper of the metering rod at an idle position. The fuel ratio tool is available for purchase please contact Fast By Gast.

  Note: Flat Side of Metering Rod Must Always Face in Towards Engine

            The metering rod that is supplied with your carburetor is recommended for a standard serial production version on your engine, in its normal state of tune. Any variations of tuning beyond the way that your engine was manufactured and subsequently maintained will effect the recommended selection and or setting of the metering rod.

          For fine LOW END tuning, turn the metering rod in direction of Arrow "A" (richer) or "B" (leaner) as shown in FIG. 2 and rotate until flat side of rod is in position as shown.

 

 

Order Hotline: 1-800-866-3880

Copyright© 2003 by Fast By Gast All rights reserved.